The foundation is the foundation of all the foundations.In any case, with regard to construction. If the quality of its filling is unsatisfactory, the house will not last long. If you are going to build a house with your own hands, it will not hurt to learn about how to knit reinforcement under the ribbon foundation.
Why knitting?
It is known that some builders when erectinghouses are used to weld the reinforcing base. We strongly advise against doing so. Why? The fact is that any welding work in the future reduces the mechanical strength of the metal.
In addition, the welding places are highly susceptiblecorrosion. Considering that any construction mixture for pouring foundations is a mixture of water, cement and filling substances, the potential danger of this method becomes obvious. So how do you knit the armature under the ribbon foundation?
Manual mode
Unfortunately, on many domestic constructionsites and to this day use the technique of manual binding reinforcement. Of course, this method is available to everyone and does not require special financial expenditure, but this is a slow process, and the qualifications of workers here play a significant role.
Automation
If you are thinking about how to knit an armature underribbon foundation, it is best to buy a special knitting machine. It will not only significantly alleviate this kind of work, but also speed up its implementation many times. Thus, the mating of one joint takes just a couple of seconds.
In addition, the wire itself is supplied on replacement coils, the recharging of which takes no more than a couple of minutes. Now consider how to knit the armature under the ribbon foundation.
Getting Started
Before knitting the armature under the ribbon foundation, it is necessary to inspect it for mechanical damage and large foci of corrosion.
Do not assume that we are too sharpattention to insignificant aspects: the fact is that a reinforcing base with foci of corrosion is a potentially dangerous element, because of which the whole structure may collapse in the long term.
Work on knitting is carried out in a strictly definedsequence. Prepared valves for filing. After that, it is brought to the installation site, leveled, brought to the design position and knit. By the way, with what step is the knit armature? Typically, the length of the overlap should be at least 250 mm.
Before the viscous reinforcing base is examined again, cleaned with a metal brush, and if necessary aligned with a hammer.
We put the reinforcement in the formwork
This is the most crucial stage.At least two people are responsible for the preparation and stapling of the reinforcement. Install and fix it in the desired position of three people. If the assembly is carried out in trenches or trenches, the reinforcing base is fed through a traverse or trays.
That's how the armature under the ribbon foundation is prepared and knitted.
