Winter greenhouse: with our own hands we make of polycarbonate

Большинство садоводов занимается выращиванием vegetables in the open ground. But because of the high humidity that forms after the rains and fogs, phytophthors and other various diseases usually arise. That all activity was not in vain, it is necessary to build a greenhouse. As a material for it come polycarbonate. In comparison with polyethylene film, such material is distinguished by its durability and reliability. And glass, as is known, has a high fragility.

Перед тем как перейти к строительству, следует to know that a winter greenhouse, built with its own hands, should be well ventilated. In addition, in order to keep the air in large volumes, it is best to make an arched roof. You will also need to create a foundation. As materials for its construction, you can use concrete, brick, stone, etc. At the time of the foundation, care must be taken to make fences for future beds. As a frame for a greenhouse, metal profiles are usually used, which have a large number of advantages over wood. If you chose a metal material for your construction, then it should be treated with a special tool that prevents the appearance of traces of corrosion.

Итак, как собрать теплицу из поликарбоната?After the foundation has been made, special racks should be welded around the perimeter. In addition to them, you must immediately install the blocks for future doors. In addition, at the top of the pillars and the door block, you need to make the top harness. It is made of a special corner and is strengthened in such a way that there is a gap between it and the posts. In this gap, polycarbonate sheets will subsequently be inserted. Based on this, we can say that in this way you protect the material from water and debris. If you decide that the made winter greenhouse with its own hands will have an arched roof, then it is necessary to order special devices made in the form of arches. They should be attached to the racks and tied together with special screeds and skates. Thus, you will give the whole structure rigidity and stability. After the design is ready, it should be painted. To do this, you need to lay the boards on the top screed. Only after this, we can talk about the full availability of the frame, which will have a winter greenhouse.

With their own hands, polycarbonate is not socomplicated. The main thing is to know some basic points. For example, laying should be done along the long part of the sheet. Self-tapping screws are usually used as a fastening system. In addition, in order that they are not pressed into the material, special thermowells should be purchased.

В первую очередь необходимо закрыть крышу, а уж then ends of arched devices. And last but not least, polycarbonate should be finished with walls. All corner joints must be closed with a special corner made of plastic or metal. On doors and windows it will also be necessary to install handles, latches, hooks and seals. All this is necessary for good sealing, which must necessarily have a winter greenhouse. With your own hands, as you can see, it is not so difficult to make a greenhouse. The main thing is to approach everything responsibly. Due to this, it will be possible to avoid temperature drops. Also, you should understand that before packing the material, you need to remove the packaging film from it. To the edges of the polycarbonate will be attached to the adhesive solution a special corner, which will protect it from moisture and debris. In order to connect two sheets between each other, it is necessary to use special slats.