How to paint the ceilings and not be upset

Repair in the heat, disputes about the choicethe color solution of the room was left behind, the materials and tools were bought, the space was as free as possible - one could start creating. But something stops. You just can not decide where to start? Well, start with the ceiling. If your plans do not indicate the order and installation of the tension structure, then you will be interested to know how to properly paint the ceiling. The process is time-consuming, and the result largely depends on your patience and accuracy.

Why do we start work from above?Simply, no matter how insured you are, but the droplets of paint will still fly down. Why once again get upset and scold yourself for just a bed, but already hopelessly spoiled flooring? Therefore, we act reasonably.

Pre-roll the floor polyethylenefilm (the floor, of course, has not yet been touched, but why bother with rubbing the spots); places that can not be tinted, pasted with special paint tape. Before painting the ceilings, we measure the required amount of color. I hope you remembered to prepare the surface? The primer smooths the surface and gives the desired density, preventing the paint from peeling off.

In order to cover exactly and do not "strip"it is necessary to apply it correctly. The main thing in the task of how to paint the ceilings is always to follow the direction from the light source (window) to the walls.

On the perimeter we work with a wide brush.Keep it correctly: the flat part is tilted to the surface, gradually increasing this angle in the direction of motion. Do not apply too much pressure on the brush to prevent staining.

The first layer is superimposed perpendicular to the window.Let the paint dry out. Do not rush the process by placing heaters in the room. Only spend, paying bills for electricity, and fresh color will go in bubbles. Be patient and wait for the composition to stick to the surface itself.

How to paint ceilings repeatedly? You need to drive the roller from the light source, but already moving parallel to the window. The second layer lies crosswise against the first coating.

The roller acts delicately.Evenly pressing, we hold the strip, not looking up from the surface for an instant. The next strip is led, slightly superimposing it on the previous one. It's okay if there are traces of the edges. They are neatly rolled perpendicular to the main direction.

Avoid drafts in the room where the finish is being carried out!

That the result of their own labors rejoice youas long as possible, think carefully about how to paint the walls. In the bathroom or in the kitchen, the paint must successfully withstand humidity. Therefore, latex formulations that are based on acrylate, will not peel off after a month. And antifungal supplements will not give mold any chance. For concrete, brick surfaces, both water-based emulsion and acrylic are suitable.

Of course, even following all the recommendations abouthow to paint the ceilings, you can find on the already finished coating small defects: marks from the roller or brush, small swellings. Nothing wrong! Deficiencies are cleaned with sandpaper and painted again.

Do not rush and do not be nervous: the calmer you will be, the more even the paint will fall. And do not scold yourself for minor mistakes, which can always be easily corrected.