В процессе сборки своей первой удочки практически each angler is asked such a question: "How to tie the float to the line?" A lot depends on the correct choice of its design, as well as the correct attachment to the rigging. There are two types of installation: deaf and sliding. The first is most rationally used in stagnant water, for example in lakes or bays where the current is either absent or so insignificant that it can be neglected. But when the surface of the reservoir is restless, it is better to use a sliding method.
Classification
Before you tie a float to the line, find out what their species are today. And there are a lot of them, and there are plenty to choose from. The most common modifications are:
- "Penguin" or "Cheburashka." They are very similar. Even seasoned
Fishermen sometimes can not distinguish them from each other.In appearance, these are quite long floats, which gradually narrow to one of the ends. They perfectly combine stability and sensitivity. Most often they are used for significant fluctuations in the surface of the reservoir. - "Thumbelina" is an excellent solution for calm standing water. In this situation, the easiest way to determine the float is when the fish begins to peck.
- "Calm" is long and thin. He has excellent sensitivity, good for fishing at a depth of 1.5 to 3 meters.
- "Maestro" - is a truncated cone.It is characterized by increased resistance. Ideal for fishing at a depth of up to 1.5 meters. The downside is that it is immediately difficult to determine the biting.
Float selection technique
The choice of the float is made on the basis of 2 factors - the surface of the water surface and the fish that you plan to catch. For example, if you plan to catch a carp on a float in
Fixation on the line
How to tie a float to a fishing line?When the sliding method provides the ability to move along the entire length of the fishing line. In practice, this method of attachment is used if there is a strong current or there is a significant fluctuation of the water surface. If the deaf mounting method is used, then the movement of the float is limited to a small portion of the fishing line. This method is used when fishing in stagnant water or in a pond with little current. There are the following mounting methods:
- due to the design of the float;
- using special rings (rubber bands with nipples or wire insulation, for example);
- using nodules from fishing line.
The easiest way of how to tieA float to a fishing line is the use of a special float design. For this purpose, special ears or a hole are provided in the float. A line is passed through them, and at the same time it is fixed on it. This method is used on industrial products. The second method is similar to the previous one, but is used on homemade devices. These two methods are used for sliding mounting. The latter is that a float is put into the rupture of the fishing line and fastened with knots on both sides. It can be used only with a deaf mount.
conclusions
Fishing floats play an equally important rolethan the rest of the gear. Much depends on their proper selection and adjustment. All fishermen, without exception, should know this, and apply knowledge in practice to achieve a positive result.