How do I burn Windows to disk without damaging the files?

Before writing Windu to disk, you shouldmake sure that the blank is clean, without scratches and other defects. If there is even the slightest flaw, then most likely, some files will be written incorrectly, and when unpacking, an error will occur. If you decide to write to an RW disc, you need to take care that no information is left on it.

Quite often there are situations whenThe downloaded image is not true. It seems like how to write Windows to a disk turned out, but autoloading does not start or passes with incomprehensible characters. This is possible if during the download there were errors or failures on the hard disk itself. In order to eliminate such problems, you need to use checksums - this is a file of information about the current version of the operating system. You can verify the authenticity of the software using a special program. If the checksums of the attached file coincide with the downloaded files, then there will be no problems.

Перед тем как записать Винду на диск, необходимо pay attention to the file format. It happens that in the computer settings the disk image is automatically detected as an archive. WinRar is designed to work with many formats, while it can open disk images. Therefore, if the downloaded file is displayed in the form of an archive, you should not make hasty conclusions. It is necessary to check its format. To do this, right-click the file properties, where the format type is reflected. Must be ISO.

If you burn Windows to disk after unzippingimage file, autoload fails. Therefore, it is important that the recording on the disk was made from the image. The fact is that in the structure of the original disk there is a special autoloading system - this is a list of files that work with the BIOS. With their help there is a transition from the normal mode of loading. When the original disk is multiplied by normal file dragging, the installation will be only superficial: when the current version is installed on the previous one, this eliminates the possibility of hard disk space marking and formatting.

Therefore, before writing Windows to disk,It is necessary to equip with special programs like Nero or CD-Burner. These utilities allow you to make a disk image. Thus, all its structure and contents are placed in one file, which is a kind of clone of the original. In this case, losing information is almost impossible.

Before writing Windu to disk,It is recommended to check your computer for viruses, but it is better to check with different programs. This eliminates the possibility of introducing malware into the disk image.

It is important that the recording is made in good order.drive. After the end of the burning operation you should check the checksums. For this special software is used. In addition, verification is provided in the Nero program - this is the operation of checking the recorded information. If the verification is successful, then the disk is usable.