How to configure the network in Windows 7

When developing the latest operating system versionsWindows systems (7 and 8) were taken into account all the comments of users collected by Microsoft over the years, while on computers used the famous Windows XP - a truly long-lived project.

As a result, the same Windows 7, compared withXP's “old lady” became more flexible in configuration (auto-tuning was modified), which could not but affect the usability of this system. However, questions still arise, and one of them is about how to configure the network on windows 7.

Reasons for some usershave difficulty working with the operating system, the most different. These may be differences in the interface of the new and old versions, the non-obviousness of some menu items, etc. However, all this difficulties are surmountable, especially if you know how to configure the network in windows 7 and not search for the necessary parameters yourself.

For the convenience of users all the necessary itemsmade in a single section - Network Control Center. Something similar was in Windows XP, however, the solution in the "Seven" is more successful, since in this system the settings of local networks and the Internet are combined. Such a "trifle" greatly simplifies the work. To remember the location, it’s enough to study once how to set up a network.

You can open the "Network Control Center" windowtwo ways. In our opinion, the simplest is to use the corresponding icon in the form of a small monitor in the lower right corner of the system tray. By clicking on it the right mouse button (RMB), you can open the required window through the menu. Sometimes on the pages of Internet resources describing how to configure a network, it is suggested to open a window through the “Start - Control Panel”. In both cases, the result is similar, but the one proposed by us is still faster.

Everything is obvious in the opened window - it is necessarycreate (or configure) a new connection. The point is called. The following is a selection of several options. Usually you need the first one, called “Internet connection”. Before we talk further about how to set up a network, we note that the number of points on different computers may differ - this is normal, as it depends on the connected equipment (Ethernet, Wi-Fi, CDMA modem, etc.). It is important to know which device will be accessed. So, wireless mobile communication modems (GPRS, EDGE, CDMA) require knowledge of the password, login and dialed phone number. “Their” item is “Switched”. For other options, respectively, the choice will be different.

In any case, after clicking will openthe next window where you are asked to enter the data that the provider provides. It is recommended to put checkmarks in front of “Display characters” and “Remember password”. The first opportunity will allow not to make a mistake with the set, and the second - not to enter the password / login again. It remains to press the "Connect" button. A connection check will be performed and, if everything is normal, this connection is created and placed in the "Change settings" tab (access from the main window of the Network Control Center). Alternatively, you can activate the tick to create a shortcut on the desktop.

It is worth paying attention that for wirelessconnections after checking and error message, you must select "Create Anyway". As you can see, there is nothing complicated about how to set up a network.