How do you make ovens on your own hands?

Since wood, gas and coal are constantly becoming more expensive,Summer residents and owners of country houses are constantly looking for ways to reduce the cost of heating season. Someone chooses solid fuel boilers of long burning, others try to conduct experiments on combining the fireplace and the water heating circuit.

But there is a way much easier and cheaper.If you have a small suburban volume, then with its heating the ovens on the working can quite handle. With their own hands, they are relatively easy to make, and such a furnace can save a lot of money.

Advantages of heaters of this kind

Such furnaces are characterized by an extremely simple installation,elementary manufacturing technology and its "eternity". Since there are no complex constructive elements, it can work for years. Given the speed and technology of disassembly, it can be transported in the trunk of the car at any distance.

Of what to do?

As a rule, craftsmen self-made the stove oncan be made of sheet metal. But access to normal metal is far from always and not all, and even a normal welder who can only gently and with full tightness weld all the seams, often not at all within reach.

Based on the realities of our life, it is better to confine ourselves tominimum of welded joints, and use an empty gas cylinder to make the kiln on the working site. With your own hands it will be much easier to assemble a couple of elements into one, without resorting to complex technological methods.

Constructive elements

Having dealt with the main points, we proceed towork. Regardless of what you will make the kilns working on, you need to prepare two circles of metal with your own hands. Suppose that their diameter will correspond to that of a gas cylinder. The chimney pipe must be strictly vertical, without any horizontally located sections!

One of the containers will be located above the other,holding on the afterburner pipe, in which it is necessary to drill a few holes for better airflow into the combustion chamber. Important! The plate, which does not reach the bottom of the container, must be welded across the upper chamber (on its upper cover).

This - a kind of "bump", from whichThe heated air is reflected by heating the chamber. If you forget about this extremely important detail, then the kiln oil on the working (with your own hands which you can make quite simply) will eat just a rip.

In the upper lid of the lower chamber, twoholes: one of them must have a damper, covering which, you can adjust the thrust, not allowing over-consumption of fuel. The second hole is best provided with a funnel through which the waste oil will be poured into the furnace.

How to Kindle?

Everything is ridiculously trite: in the lower compartment pour about a liter of oil, we put there a small amount of set fire to paper. When the oil inflames and boils, we pour in another five liters.

A detailed drawing of the furnace on working is better to ask to make a good locksmith, as it can provide a sidebar for the water heating circuit, as well as other useful devices.