How to make a kiln on waste oil by hand?

A large number of people often facethe problem of heating a greenhouse, a garage, one of the rooms still unfinished giving and so on. Of course, the solution to this problem may well be the purchase of special heating equipment. But is it not better to make a kiln on waste oil with your own hands? Moreover, it is quite simple, and from the economic point of view it is much more profitable than buying equipment in the store.

So, let's give a brief instruction for creating such aheating element. In fact, this furnace on waste oil consists of only four main parts. This is a chimney, two tanks and a connecting pipe for these tanks. And it is worth noting in advance that the lid of one of the tanks (top) should be reinforced, because it will burn quickly.

Also, if you create an oven on waste oilown hands, you need to take into account some features of the connecting pipe. Do not use a pipe with a diameter of less than 100 mm. And its minimum length should be 400 mm. In general, it is highly desirable that this same length be about four times the diameter. Through the whole surface of the connecting pipe, holes with a diameter of 9 mm are drilled. Such holes need about 50 pieces.

Also, making a kiln on waste oilhands, do not forget about the chimney, which again has some of its features. It is quite logical that it should be located above the upper capacity. It should be borne in mind that its foundation must necessarily be heat-resistant. As for the further length of the tube - it can be performed

even from tin.By the way, regarding the length, it is desirable that the hood for smoke is up to 7 meters high. But if necessary, you can reduce it to four, not less than that. In some cases, in order to increase heat dissipation, such a pipe is inclined at a particular site. But at the very end it must be strictly vertical, so that the wind does not blow it. If necessary, you can make a special cover that will protect the chimney from getting into it rain or snow.

Now the oven on the waste oil is almost ready with its own hands. It remains only to understand the bottom capacity. This capacity, as well as the upper one, is covered

cover, which is welded to the connectingpipe and top capacity. There must be absolutely no gap between this cover and the capacity itself. But it is necessary to have an adjustable hole for refilling with oil and for access to oxygen. And do not forget that the entire structure should be placed on special legs. In general, everything, the furnace is ready.

Finally I would like to note that suchWaste oil heating has some significant advantages. First, this is the aforementioned economy, because working off is really inexpensive. In addition, the operation of such furnaces is considered to be environmentally friendly, they do not smoke at all. Well, the mobility of equipment. The oven is very simple, easy to disassemble and transported.