Problems with the work of plumbing in the house ariseoften. The most common phenomenon that causes discomfort in residents is the appearance of unpleasant sounds in the system. Let's consider why the water pipes are buzzing when the crane is turned on.
Poor installation of system components
Close arrangement of pipes
Why are the pipes hummed when you open the tap?Often such a phenomenon is observed in cases when the elements of the water pipe are in direct contact with each other. To solve the problem, it is necessary to find closely located pipes. If it is not possible or difficult to change their configuration, it is enough to wrap each water conducting element with special polyvinylchloride insulating casings that can be purchased in any sanitary ware shop.
Excessive system pressure
Excessive pressure level in the water supply systemIn time, it may lead to the depressurization of certain structural elements and the flooding of housing. To reduce the load on the pipes and remove annoying sounds, it is recommended to resort to installing a special pneumatic camera. The latter is mounted at the junction of the mixer with the pipe and assumes an overpressure.
Finally, to be convinced of the presence of such athe causes of buzzing and buzzing in the system will allow the call of plumbing, which will determine the level of pressure in the water supply system. Normally the indicator should equal 2 atmospheres. In this case, the mixers, dishwasher and washing machine will not be subjected to destructive effects. If the pressure in the system is 6 atmospheres or more, this is the reason for handling the complaint to the service provider.
Clogging of pipes
The decrease in the internal diameter of the pipes is known asdefinition of a "heart attack of the pipeline". There is a phenomenon in homes in which for a long time there has not been maintenance or repair of capital engineering systems. From the inside, the pipes are overgrown with rust, salts, all sorts of rubbish accumulate here. In the most difficult cases, to fix the problem, they resort to installing new metal pipes or installing plastic connections.
How to determine if the causediscomfortable sounds lies precisely in the presence of clogging inside the pipes? To diagnose blockage, it is necessary to dismantle any section of the water pipe and look inside. The presence of plaque and dirt on the walls of the pipes will confirm the conjecture.
Removing blockage in pipes can also be done bymechanical or hydraulic flushing. In the first case, it is necessary to drain the water from the problem area and use a thick wire, at the end of which a metal brush is fixed. For hydraulic flushing systems resort to the use of a powerful circulation pump, which is able to rapidly drive water through the pipes under high pressure.
Old, damaged pipes
Damage to the mixer washer
Now consider the most commonThe reason why the tap is droning. The most common problem is the presence of defects on the mixer shim. The latter can be worn, incorrectly installed or defective.
To fix the problem, you must do the following:
- Alternately open the tap for hot and cold water. This will reveal where the damaged gasket is located.
- Shut off the water supply in the apartment.
- Disassemble the mixer and remove the damaged gasket.
- Buy a new design element in the sanitary ware shop and install it.
- Collect the mixer, turn on the water and check if the buzz in the tap has gone.
Insufficient fastening of hoses for water supply
Malfunction of the cartridge
Most modern single-lever mixerscontain a cartridge that is responsible for the distribution of water flows. It is likely that the cause of the appearance of unpleasant sounds in the water supply system lies in its damage.
To replace the cartridge, the following tools are required:
- adjustable wrench;
- Screwdriver Set;
- knife with a thin blade;
- hexagon.
Before carrying out repair procedures,shut off the water in the apartment. Then, use a screwdriver to touch the button that indicates which side of the cold and hot water supply is from. Next, you need to unscrew the cartridge holding the screw with a hexagon. Finally, using the adjustable wrench, it is necessary to unscrew the clamping nut and remove the represented structural element.
To find a cartridge similar to the one available, you canin the plumbing store. After completing the purchase, it remains only to assemble the system in reverse order, using the above tools.
Hose leak in the shower
To solve the problem, it is first of all worth checking whether all the same gaskets are damaged. If the reason lies in this, you need to replace them.
Sometimes the appearance of unpleasantthe inclusion of water in the shower causes the rupture of the hose itself, namely its internal rubber tube, which is located in the middle of the metal sleeve. To deal with the trouble, it is necessary to seal a gap with a patch. However, those who do not wish to burden themselves with unnecessary work, it is best, of course, to buy and install a new hose.
Finally
However, resort to the repair of sanitary equipmentis recommended only to those persons who already have experience of doing similar work. After all, ill-considered actions can affect the functioning of the entire water supply system. When performing incorrect repairs, it is possible not only to leak water, but also to create a serious emergency situation. Therefore, in some cases, to eliminate unpleasant sounds in the tap or elements of the water system, it is worthwhile to resort to the services of professional masters.