Проблема с разрядившимся аккумулятором знакома every car owner. And often this happens on the day when you just can't do without a car. In this case, the question arises of how to start the car with the pusher. Today we will look at how to do it right.
rules
Для начала отметим, что просто так машина не start up with a pusher. This can only be done if your brake system is in absolutely good condition. You will also need to find another car that will serve as a tug. If there is no such person, physical strength will also fit. Ask your friends or neighbors to push your car. 2-3 persons are enough for this. Before this, be sure to stipulate the conditional stop signals that can be sent from the window or the horn.
If you have a carburetor machine, before startingYou must also pump fuel with the accelerator pedal. To do this, it is enough to make 2-3 clicks to the floor. If you have an injection car, such manipulations should not be done.
Exhaust condition
Перед тем как с толкача завести машину, обратите attention to other points. If you encounter this problem in the winter, be sure to check the condition of the exhaust pipe. It should not be clogged with ice or snow. Ice is a sign of frozen condensate. In this case, you can not start the engine. Although you can try - it will not lead to the failure of the belt and other important elements of the car. What needs to be done for this? To do this, remove the battery and take it to a warm room. It is better to immediately put it on the battery. But do not forget that the battery should not be very hot. Therefore, we put it at a short distance from the battery, and not on its surface. It will take about 2-3 hours to warm up. After that, put the battery back into the car and make a launch.
If the pipe just snow formed, clean it and hope for a successful start of the engine. In this case, you do not need to warm up anything.
How to start the car with the pusher on the "mechanics"?
If all of the above rules are met,You can start to start. So, how to start a car with a pusher (injector)? First, insert the key into the ignition and turn it. Next, turn on the "neutral" and give a conditional command to people so that they start pushing you, or the driver of the second car to start pulling.
When your car began to move a little, you need to squeeze the clutch and engage the second gear. After this, a push should occur, and the engine will start in this case.
Again, squeeze the clutch and, if necessaryslow down. In this case, the gear lever is moved to the neutral position. In order to avoid trouble, all the above described manipulations should be carried out as clearly and quickly as possible.
Everything, our engine started.Now you can give the appropriate signal to the tow or to people pushing behind. But in order for the engine to warm up normally and not stall again, let it work for about 15 more minutes.
Что делать, если машина заводится с толкача плохо?As practice shows, sometimes motorists can not start the car the first time. In this case, you need to repeat all the above steps again. This is done until the machine starts. After starting, do not forget to recharge the battery, so you do not have to push the car again.
How to start the car with a pusher on the "machine"?
Almost all motorists say thatAn automatic transmission cannot use such a method of starting the engine. And there are objective reasons for this. The fact is that the automatic transmission has a slightly different principle of operation.
The essence of starting a car with a pusher isthe ability to transfer torque from the wheels through the transmission to the engine. In vehicles with an “automatic”, when the engine is turned off, the gearbox also does not work, as oil sediment only pumps fluid when the engine is running. In other words, on a muffled car there is no connection between the wheels and the engine through the box. Accordingly, when towing a vehicle, the torque forces will not be transmitted to the engine, and the piston group will remain stationary. However, some craftsmen produce start the car, even with such a transmission.
How to start a car with a pusher with a box machine? To start the engine, you must perform the following steps:
- In tow, the car accelerates to 50 kilometers per hour. Understandably, you will not limit yourself with one physical strength of a neighbor - you will have to look for another car.
- Having traveled at this speed for several minutes, we shift the gearbox lever from the neutral position to the drive mode (on the gearshift knob it is marked with the symbol D).
Запуск двигателя после такого вряд ли кто может to guarantee, and in practice for most of such experimenters, the transmission simply fails. In general, it is not for nothing that motorists say that it is impossible to start a car from a pusher on an automatic gearbox. Therefore, in order to avoid costly repairs, which will “take away” several hundred thousand rubles from you, it is better not to use this method and, in extreme cases, use a taxi.
note
It should be noted that it is not safe to start a car with a pusher, even for a manual transmission. The fact is that after such actions you risk cutting off the timing belt.
Conclusion
So, we figured out how to start a car with a pusher andwhat dangers await motorists with an automatic transmission after a similar engine start. Finally, we note that for a better start in the winter, it is better to remove the battery every day after the trip in the evening and put it in a warm room for the night.
