Автомобильные стеклоочистители имеют большое value for a comfortable ride. Thanks to their work, good visibility is achieved on the road, and the driver will better preserve his suspension, as he will see and go around the pits and other irregularities. The better wipers work, the better it will be for the car as a whole, and the driver will be calmer. When the quality of work falls, it is time to replace the wipers. However, sometimes you can only change the gum for the wiper blades.
Let us consider how to do this, and at the same time how to extend the life of these details so that their work is of high quality for as long as possible.
Before cleaning
Wipers drivers really startappreciate when you are driving in bad weather. It is thanks to them that a good overview is provided at this time. In order for the wipers to serve as long as possible, they should be properly operated. For example, before you turn on the cleaning mode, you need to moisten the windshield. If there is no liquid in the tank, you can pour water from the bottle or use snow. It is better not to drive on dry glass, as this may cause damage to the rubber for wiper blades. Especially a lot of dust and dirt accumulates on the rear window. If you hold a dry rubber band on them, then cracks and abrasions are formed. Naturally, from one time this will not appear. But over time, they are necessarily formed.
Sometimes it is useful to wash the brushes with water, and you should not forget about the gum for brushes.
We take care of the brush in the winter
In the cold season, they need special care.If the car remains for an unknown period on the street, then they should be taken away from the windshield, as they can freeze in severe frosts. Once in the car, in no case can not immediately turn on the device for cleaning the windshield. After all, the brushes and the motor that starts their mechanism may wear out ahead of time.
When the weather changes, the fluid should be replaced.washer on antizamerzayku. Thanks to this gum for wiper blades will last a couple of seasons. At the same time, it will keep the tank intact, since it can crack if it is filled with ordinary liquid.
We take care of the brush in the summer
It is necessary to take into account, on the other hand, that whenbrushes get direct sunshine, it reduces their service life twice. Therefore, if you do not want to buy new brushes or rubber bands for wiper blades after the summer season, take care to remove them from the car. It only takes a couple of minutes. But the money will be saved.
Some more tips on using janitors
It's also a good idea to wipe the habit.glass, for example, when refueling a car. The most vulnerable part of the wipers is their hinges. They need to provide proper care: lubricate them so that corrosion does not occur and they do not wear out ahead of time, or the mechanism will have to be changed again.
When snow is on the windshield, it is better to wipe it off with a hand than with a wiper, or use a scraper. The wipers turn on after the snow has cleared.
Do not turn on the janitor if there is a layer of ice on the glass. Friction can lead to cuts on the elastic bands, after which you can forget about high-quality glass cleaning.
Replacing gum
But no matter how carefully you look afterjanitors, sooner or later there comes a time when they have to change. However, do not rush and throw out the old set. Maybe the reason for the poor performance is the wiper gums, since all other parts are more durable and break less often.
Let's take a look at how to replace the gum.on the wiper blade, and try to implement it. Perhaps, then with the old set of brushes you can safely ride a few more seasons, and use the money saved for something else.
Instructions
To change the gum, not necessarilyride to the auto repair shop. The main thing is to choose the correct length of the rubber tape. To install, you will need pliers and scissors or a knife, as well as the tapes themselves. Suppose you have purchased good rubber bands for Bosch wiper blades. The replacement process will be as follows.
It is necessary to raise the levers of cleaners from the driver's side, and then from the passenger side. It is better not to open the hood when replacing, as the wipers may break.
Then the gum is removed from the mount. It will be easier to do if you use a pair of pliers to unzip the fastenings literally a couple of millimeters so as not to break them.
Then gently pull the end of the gum and pull outit is with guides or, as they are also called, ribs. Rubber bands for Bosch wiper blades are most often bundled with guides. But sometimes they are sold separately. In the latter case, the ribs are installed on a new tape and, if it turns out that the gum is longer than necessary, quietly cut off the extra piece with a knife.
Next, set the wiper back.Make it easier than remove. But you need to be careful not to damage the small parts. The elastic is inserted between the fasteners, fixed and clamped with pliers.
The final step is lowering the arms on the windshield. First, lower the passenger side and then the driver.
This whole procedure is applicable not only to frontalglass Similar actions are taken when replacing the tape on the rear window. If you pick up good gum wiper blades and properly install them, then you extend the life of the wiper set. Of course, this will be possible if you follow all the recommendations for the use of these parts.
Conclusion
Thus, if you use gum forwiper blades (Denso, Bosch, Alca, Horse, and others) can significantly save on the purchase of wipers. Proper care will keep them in order for a few more seasons. At the same time, the replacement procedure is so simple that it is easily carried out independently and does not require the help of specialists.
