How to seal a boat out of PVC yourself: the features of the process

If you have a question about how to gluea PVC boat with your own hands, then this article will be useful for you. Everyone knows that polyvinyl chloride is a very common and practical, but short-lived material. Therefore, sometimes boats made of PVC can be damaged. If the hole in the product is large enough, it is better not to risk self-repair, but to turn to a professional. If the damage is not very large, you can try to correct the situation yourself.

So, how to seal a boat out of PVC?First of all, it is necessary to determine the exact location of the damage. To do this, you will have to slightly inflate the product and lower it into the water. In the place where you notice the bubbles, there is a hole. Next, using a pen or marker, we draw a puncture. In principle, you can come up with another notation.

To work, you will need a few patches andexclusive use glue. In principle, if you bought the product in the store, you should have received a repair kit in the kit. However, if you do not have it, you should choose a material close to the boat for color and quality.

Let's say you already know how to seal a boat fromPVC. Now you need to clean the damaged area, dry it and degrease it. As for the patch, it should be slightly larger than the hole itself. Usually it has an oval or round shape. If you leave the corners in the patch, then it may accidentally peel off. To degrease rubber, you can use acetone.

If you do not know how to glue a boat with a gluePVC, it is necessary to choose exactly what is intended for products made of polyvinylchloride. If the hole is too large, then it must be sewn neatly in small stitches, and then patch it. It should be noted that it is necessary to take two new pieces, since it is desirable to glue both from the outside and from the inside. Although this will have to further cut the product.

Determining how to seal a boat made of PVC, you needapply the substance to the hole and allow it to dry slightly. In this way, you further seal the hole. Now you can apply a second coat of glue and apply a patch. Naturally, it is desirable to put it under any load for 24 hours. During gluing, make sure that there is no air left under the patch. After the repair, the boat should not be launched for a couple of days. Before use, it is advisable to check the quality of the bonding of the patch. To this end, place the repaired place under water, and the product must be inflated. If there are no bubbles, then the hole is sealed up qualitatively.

If you are not sure that you will be able toprocedures to produce independently, it is better to immediately trust the professional. It may be necessary to make any other procedures and patching will not be enough. It is necessary to remember that it is already harder to repair the product again. The thing is, you have to clean up again and prepare the damage site, and this is more difficult to do. Now you know how to properly seal a boat of PVC. Good luck!