Technoelast EPP is used to create a canvasroofing of buildings and structures, waterproofing protection of foundations, basements, as well as other structures that are subject to constant pressure and deformation. It is very durable and elastic.
This product is SBS-modifiedroofing multifunctional waterproofing material. Its application provides the maximum level of reliability. Technoelast EPP is mounted by fusing. It is a lining material, so the correct arrangement of the roof or waterproofing implies a mandatory overlay of the top layer. The material is very practical in installation and operation.
Waterproofing
Technoelast EPP under loads and pressure notdeformed. The material simply stretches, preserving the integrity of the structure. The cloth does not rot and is resistant to temperature changes. It is designed for waterproofing the following types of objects:
- swimming pools;
- garages underground;
- boiler rooms;
- industrial and loaded roofs;
- the vaults of the underground;
- foundations.
This material is perfectly combined with the technoelast EKP (a product for creating an outer layer).
Composition
Техноэласт является битумным материалом, a polyester base, an astringent layer based on polymers and a special protective film. This canvas can be considered duplicated. On its basis from two sides the composition of bitumen, butadiene-styrene thermoplastic elastomer and filler is applied. The latter also has two-sided protection (polymer film). The basis of the canvas is white polyester, which consists of individual fibers. Thanks to it, the technoelast EPP is distinguished by its high strength, resistance to high humidity and atmospheric precipitation. Compared to fiberglass, which stretches only within 2% of its size, polyester is very plastic. Therefore, it is more suitable for operation in conditions of deformations and severe loads. Technoelast EPP - biostable material. From below and from above it is covered with polyethylene film, which protects the web from gluing during transportation or storage in rolls.
Installation
Stacking of technoelast EPP is carried out withusing a gas burner using the fusing method. All work should be carried out, following the sequence of actions. To begin with, prepare the foundation. It is necessary to remove all rubbish, seal pits and cracks with special repair composition on cement-sandy basis or mastic. Then it is necessary to prime the surface with bitumen-gasoline solution (1: 3) or primer. It must completely dry out. After that you can start fitting. The rolls are unfolded and laid out on the base to estimate the desired volume for styling. If necessary, you can cut the material with a roofing knife. Then it is rolled back into rolls. For melting, the technoelast and base are heated evenly and simultaneously. The roll is gradually rolled out, and the web is pressed against the surface. It is overlapped (80-100 mm).
Features of waterproofing
Technoelast EPP is very high quality andmodern material. It has excellent technical characteristics and is relatively cheap. Of course, its price is somewhat higher than that of conventional counterparts, however, this material is very economical, which results in greater benefits. In addition, this waterproofing roofing sheet is much easier and more convenient to lay. And it serves for a very long time, which makes it possible to pay back its cost.
Technoelast EPP-Thermo
This material is supplied in rolls.It is a SBS-modified roofing and waterproofing fabric of high reliability. The material is used to create roofing carpets, arrangement of waterproofing foundations and other capital structures with high requirements for reliability. It can be used in all climatic zones. In contrast to the standard fabric type, technoelastic-thermo has an increased heat resistance, which significantly increases its service life. When heated, bituminous compounds do not evaporate into the atmosphere. This material is very durable and elastic. Its application provides the highest reliability and durability of the waterproofing roofing layer.
