If you are interested in the question of how to make ringswith your own hands, then this material is for you. There are many variations of homemade jewelry, only a few of them will be described later.
For the first ring with your own hands you will needa pair of beads and a wire. Naturally, in addition to the materials that will be used to create jewelry, you will also need tools, among which you can identify pliers with a thin nose, as well as wire cutters and preferably round-nosed. To facilitate the work, you can stock up with an adhesive tape, a marker, as well as a round shape for rings of different sizes, which may not be available for you. It can be replaced with any round object, the diameter of which is slightly smaller than necessary. The wire should be such that it normally passes through the hole of the bead that you are using. In the future it will be possible, if desired, to adjust the size of the ring on the arm.
Now you can go directly tomaking a ring with your own hands. First, you need to cut two pieces of wire, the length of which should be three times the required size of the ring. In the middle of each of the segments you need to wear a bead. Now you need to take the pliers with a thin nose, and then bend the wire down at right angles. When you bend both wires, place the pieces next to each other. One bead needs to be placed slightly higher than the other, and the wires should be positioned relative to each other in such a way that the base of the ring turns out to be flat. They can be attached with adhesive tape for convenience.
Now to create a ring with your own hands you needmake another piece of wire coils around the base, fastened with adhesive tape, as close as possible to the nearest bead. Mark the marker to the desired length, and then continue to do the turns. The wire should be wound up to the required length, and then cut off the remainders with the wire cutters, and firmly fix the wire to the base with the help of pliers. It was the turn of the metal form for the ring. We wrap the workpiece around it until we get the ring. Now you need to trim the remaining ends of the ring, making them look like a cascade. Using kruglogubtsev of them you need to make curls. If you use expensive materials for making a ring with your own hands, then the product will turn out to be chic. You can, for example, take silver wire and Czech beads.
If you are interested in the question of how to make a ringwith his own hands of paper, then there is an answer to it. You need the following: beautiful colored paper, clerical glue and PVA glue, scotch tape, scissors, round object, the diameter of which coincides with the diameter of the finger. The ring that is offered for manufacturing will be 5 millimeters wide and 2 thick. For this thickness, you need to make strips of paper with a total length of one and a half meters. One end of the paper tape should be fixed on the substrate with adhesive tape, grease the strip as much as possible with clerical glue, and then wind up as many turns as necessary to achieve the optimum thickness. The last bar should have a drawing that you would like to see on your ring.
Now it is time to process the product forgiving it strength. This will help us glue PVA, because when dried it becomes completely transparent. It must be poured into a small container, and then immerse the ring there. The glue should soak it well, especially the butt ends. Dry the ring in a suspended state, preferably turn it over periodically so that it does not stick to the drying site. After drying, the glue will become transparent, so you will see the selected picture.
Try to make jewelry yourself, then wear them with pride.
