Even 20 years ago, the question of how to collect airsnake from improvised means was very relevant. Buy it in the store was unreal. And to assemble independently was considered a task of increased complexity. Now the situation has changed. Only the demand for kites has fallen dramatically, which is very wrong. The proposed article describes the procedure for the manufacture of two designs of such aircraft. Their main advantage is that you can make at home from what is available.
We will need
Before you collect the kite, firstqueue pay attention to the frame. For its manufacture, we need thin wooden sticks. They should be light, strong and well dried. The frame proportions are usually 4: 5 or 4: 6. It is with this aspect ratio that the best aerodynamic performance can be achieved. For the assembly, either threads are used complete with glue, or adhesive tape. Also
Option one
Now we will understand how to collect airsnake the easiest way. First you need to take 2 sticks with a length of 120 and 90 cm. On the first one, make a mark at a distance of 30 cm from the edge. In the second we measure out the middle. In place of these notches, the sticks are fastened together perpendicularly with adhesive tape or thread with glue. Next to this frame is put on a durable garbage bag and with a certain step (2-3 cm) is attached using all the same tape. On the edges of the stick 90 cm long attached fishing line. The tail is attached to the back. It can be made from fishing line and pieces of a package that will be tied on it. The result should be a diamond with a tail. After the done manipulations, the snake is ready to launch.
Option Two - More Difficult
Slightly more difficult to make a snake in the form of a rectangle.One of its sides should be 58 cm, and the second should be 45 cm. The diagonal is 75 cm at the same time. It is this length that both rods have to be, which form the frame of this air vehicle. Also
The assembly procedure for this snake is as follows:we set the front bar, and on each side we put two diagonals crosswise. All three joints are attached with adhesive tape or thread with glue. Then a plastic garbage bag is put on the resulting frame again. The rest of the algorithm of how to properly assemble a kite, is similar to the previously described. Even the components are exactly the same. It is worth noting that it is much more difficult to do. There are no clear angles, and they need to be determined by selection or complex mathematical calculations. It is not always convenient. Therefore, this method of solving the problem "how to assemble a kite in the best way" is suitable for more experienced craftsmen. Only after successful assembly of a simpler snake can one proceed to a more complicated, second variant.
Afterword
Now you know how to assemble a kite. The instruction consists of such basic steps.
- Making a frame of the boards.
- We put on him a plastic bag.
- Add to all this tail.
- Attach the handle.
The rest (decoration and addition with any details) can already be added at your discretion.
