Stork of plastic bottles with their own hands - there is nothing complicated!

Stork of plastic bottles with their own handsis done without any problems. For this it is only necessary to prepare well and be patient. Most of the materials required for manufacturing are necessarily in the required quantity in most dacha or garden plots. A similar situation exists with the tool, which is also available. So it turns out that to create an artwork you only need time and desire. All this, if necessary, can be distinguished.

Materials and Tools

During the manufacture of such a figurine, as a stork of plastic bottles with their own hands, the following components are needed:

• Sturdy, but still light enough 5-liter capacity;
• wire with a large cross-section (8-10 mm);
• Plastic tube or rubber hose, the inner diameter of which is slightly larger than that of the wire;
• a set of white and black plastic bottles;
• Styrofoam;
• a segment of a welded wire mesh;
• glue;
• wooden circle.

From the tool you will need:

• pliers;
• scissors;
• knife;
• marker black.

Before the work is done, it is best to prepare a picture for the work to be done.

The basis

Stork of plastic bottles with their own handsis done for quite a long time. Beginner masters can take up to 10 days to do this. So before work it is necessary to have patience. The frame is a 5-liter container, which is dressed in two wires. At the first stage, the side and the bottom are cut out, except for one seam on the lower side on the other side. The cut out section is lowered to the middle of the container and its top is fixed by wire or screws. Also, the pen is removed if it is present. Wire bends Russian letter "P". Its bottom is fixed on a wooden circle, but before that, it is put on either a pipe or a hose. It is enough only to hide two parallel sections. The received supporting structure is put on the 5-liter canister through the previously cut out. The mesh is put on the top of the canister and fixed with wire. The basis for making a stork of plastic bottles with your own hands is ready.

Finishing work

At the first stage of finishing works, we cut feathersbirds from plastic flasks. Next, it is necessary to distinguish between the white and black parts of the trunk. To do this, apply the corresponding line marker black. Then, with the help of glue, the lower part of the body of the bird is pasted with cuttings from black containers. While the result obtained earlier dries, make a head of foam with a knife. As the eyes use buttons that are glued in the holes. The beak is cut from plastic containers of any color and then covered with a red helmet. After it has dried, it is fixed with screws. The head and trunk are connected with a wire. It is advisable to make as many of these stitches as possible, but you need to make sure that they are not visible.

Then you need to stick the remaining white feathersin the upper part of the trunk, around the neck and head. As an alternative - you can cover the last two elements with a thick layer of white paint. Then the legs are painted red. All this must dry up. At the final stage of making a stork of plastic bottles, we make feet assembly. To do this, cut out 8 fingers of the necessary length from the plastic. They are fastened on a wooden circle with a thin wire and covered with red paint. This must be done very carefully, so as not to get the bottom out. Everything, the work is ready, and after the last components have dried out, it can be carried to the garden.

Summary

Crafts from PET bottles are purchased every daymore and more popularity. With the help of this material, you can do whatever your heart desires. The proposed option is only one of many. It can be considered as the base one. By adding something of your own, you can get a completely unpredictable result.