/ / Knitted stitches: variations and methods of implementation

Knitted Sutures: Varieties and Methods of Implementation

After the process of knitting a sweater, dressesor any other product all its parts must be connected. But this is not done with the help of a sewing machine, because its line is not elastic, and the threads will necessarily break when stretching knitted parts. Special knitted stitches are used for sewing knitted elements. There are several types of them. They are performed by different methods, tools and threads. Most often used special needles for wool or for embroidery with a blunt tip.

Preparation of parts for stitching

Before you make a knit stitch, allelements of the product must be given the correct shape after knitting. This is done by heat treatment. In order to avoid deformation of knitted parts during ironing, they are pre-attached with pins to the pattern. Remember that products from wool yarn and synthetics through cotton fabric should be steamed, and from wool, linen and cotton - ironed carefully. Attention! The process of heat treatment is always done on the reverse side, and the rubber bands should not be touched at all so that they do not stretch out.

knit stitch loop in loop

Knitted stitch "loop in loop"

Used to connect parts relatedstocking viscous. The main advantage of this method is stealth. These knitted stitches are made of threads from which the product is knitted. Open loops of one part from right to left are stitched with loops of another. The thread is fixed from the wrong side of the upper part. Also, a needle is inserted into the first loop from the inside. Then the thread should pass through the first loop on the front side of the lower part, then through the second loop from the inside of the lower part. The thread is again put into the upper first loop from the front side, then from the wrong side, into the upper second loop, etc.

Vertical seam

knit stitches

Vertical stitching of parts is done withface side. Alternately, the left wall of the loop of one element and the right loop of the second are captured. In the garter stitch used knit stitches "lacing". A needle is inserted between the last two loops, under the horizontal thread of the first part, then under the transverse second. Stitches are done horizontally.

Kettelny seam

It is used for edging the edges of the products and connecting the wards, slats, pockets, etc. At once, a 3 cm wide knit is knitted, after which it is applied and tied onto the part

how to make a knit stitch
from the front side so that the edges of the elementthey went under the strip about 0.3 cm. The loops of the planocht should remain open - they are attached with catalum suture. For this you need a thread with a length equal to three finishing strips. The needle is inserted into the second eyelet from the inside, then into the first one from the top, and the thread is pulled through the third loop from bottom to top. Then again the needle is inserted into the second loop, but from above, and pulled through the fourth loop from the bottom up. This stitch is also called the “back needle”. Before performing keta knit stitches, it is necessary to carefully loop the loops in order to avoid their “running away” in the process of joining parts.