/ / Install the standard size door: how to do it?

We set the door to the standard size: how to do it?

standard size door
If you decide to install it yourselfinterior doors, we advise you to immediately be patient, because in this case a lot depends on impeccably accurate following all instructions. If you do something wrong, then even a standard-sized door will not fit in at least a standard door frame. Therefore, we strongly advise you to carefully read our article and only after that begin work.

Before installing the doors should be a draftprocessing openings. Simply put, they must be cleaned of the remnants of old plaster, paint and wallpaper, leveled and filled. If you do it right, then a standard-sized door will be installed much easier.

Very important!All the "wet" work must necessarily be completed before the installation, and all surfaces by that time simply must be dry. Wood is a capricious material, and from dampness it is almost guaranteed to “lead”. If you plan to do something with flooring, it is necessary to do it again before the start of the door work, otherwise you will suffer with determining the height of thresholds and other similar parameters.

standard sizes of iron doors

We mount racks

Even a standard size door is crooked.installed box will look ridiculous. Moreover, even with the slightest irregularity, you will have to open the door almost with a kick. By the way, the adage about seven dimensions and one segment is the best suited to this operation. But there is no need to be afraid: if you do it carefully and do not hurry, then you will succeed.

Before starting work it would be nice to purchasemiter saw: with it you can do door frames with perfect accuracy. If there is no money for such a tool, still scrape the cash for buying a small tooth hacksaw for the highest quality and even cuts. Immediately measure the required height of the rack, focusing on its inner surface. Saw off the ends at an angle of 45 degrees, set the upper jumper and the threshold (if necessary). We fasten the construction with screws and try on the opening. If everything is in order, and the door of a standard size came to your box, then we continue to work.

standard sizes of wooden doors
Mounting loops

No less careful should be approached toinstalling loops. We measure 20 cm from the top and bottom of the box (on the side you need), then we attach the loops to the designated sites and draw a contour with a pencil. It is best to make a sidebar milling cutter, but in most cases you only have to dream about it, so the chisel is sometimes the only reliable tool. Try to cut the seats under them as even as possible: the standard dimensions of wooden doors suggest that the hinge will be completely recessed in the end. Otherwise problems with their opening and closing are possible.

Hitch

Коробка вставляется в проем, после чего при the help of self-tapping screws and struts is previously attached. With maximum accuracy, we align it with the construction level, after which we finally plant it on self-tapping screws. Fasten the loop to the joint. We eliminate all defects found, after which we close the remaining slots with assembly foam (do not be too zealous with its quantity).

Being accustomed, you can try your hand at installing more serious constructions. In particular, having studied the standard sizes of iron doors, personally put one in your own house!