How to connect a running water heater to the system?

Вы уже определились с выбором прибора для нагрева water? Here already and the purchase was made, there is very little left: connect the device to the water supply system. It is not always easy to do this. Every man who is used to doing homework himself knows how to connect a running water heater. But in some situations it is desirable to call a specialist. Suppose, if there are plastic pipes in the house, then the installation should be carried out using a special method of cold welding - soldering. Let's look at the instructions on how to install a running water heater.

Water connection

Before proceeding with the installation of the water heater, it is necessary to make a connection point to the power supply. There are two types of water heaters: electric and gas.

1. How to connect a flow-through water heater toelectricity? Everything is simple enough. First you need to check what current can withstand the domestic electricity network. If you understand this, then there will be no problems: you can safely put the machine (electric power switch) and connect the device. In the event that the mains can not withstand the voltage from the water heater, consult an electrician. It may be necessary to change the whole electricity supply system in the house.
2. Как подключить проточный водонагреватель, working on gas? To begin with, even this device needs electricity. The gas column has a panel of programs that run from the mains. But in the process of heating the liquid only gas takes part. This type of fuel in the combustion process emits enough heat to heat the water.

Connection Features

How to connect a running water heater?Each model of this device has two tubes: for cold water (input) and for hot (output from the heater). Before connecting the device, determine for what needs you need it. If the hot water you need only in the bathroom, the output from the device can be directly connected to the tap near it. In this way, residents of apartments are most often used, since they need a running water heater only for the period of switching off the centralized hot water supply. To do this, you can connect the device directly to the mixer in the shower. Residents of private homes in this regard are unlucky: they do not have the opportunity to receive warm water from the central system. In the case when it is necessary to ensure the flow of water to the kitchen, into the sink, shower, the water heater is installed on the entire system of water supply to the house.

Advice

1. The first step before attaching the flowwater heater - installation of a power source. This approach is not only rational, but also safe, since there are often cases when the owner overestimated the electrical system's capabilities in the house and as a result received the burned wiring. Moreover, the connection to the power supply must be correct so that the plugs on the counter do not knock out from the high power of the device.
2. Before buying a heater, consult a specialist to not regret afterwards the low power of the device and the poor heating of the liquid.
3. If you are going on vacation or at a dacha, do not forget to turn off the machine on the power panel. This will protect your apartment from possible troubles.