Knitted things are so exquisite and cozy that theirunable to replace any other clothes. Confirmation of this is the openwork blouse. It is knitted or crocheted - it does not matter at all, in any case it will be very feminine and original. It combines romanticism, tenderness and sensuality. And if it is handmade, then it has a soul and is priceless.
Before you get started, you need todecide on the model, thread and knitting. It is especially important that they match each other in diameter. On the labels of the coils usually write recommendations for the choice of the spokes. How to knit openwork blouse with knitting needles, which pattern will fit the yarn and which one is better to choose a model? Consider everything in order.
Calculation and start of work
Such a thing will look good if you choosethin threads, and they can be both with pile and without it. Before a set of loops for the front panel of the sweater, you need to calculate how many of them are needed. This question becomes irrelevant only if the openwork blouse with knitting needles knits according to clear instructions with the exact selection of the recommended threads. But if you knit from a yarn of a different thickness, then you definitely need to make a sample.
So, how to knit openwork blouse with knitting needles and howcalculate loops? First of all we take the pattern scheme and knit one rapport of the main pattern. Next, we measure it and, based on measurements of the chest and thigh girth (count by the larger value), we determine what number of loops you need to dial. For this, the half-grip is divided by the size of the repeat pattern and rounded to the nearest whole number. Thus, we obtain the number of rapports for the front and rear blades. Openwork blouse knitting needles fit quite easily, even though this process accommodates some calculations. To create things you can use any pattern you like.
The sweater can also be knitted from a thick thread,only for him it is better to give preference to simpler drawings and narrow rapports. Beautifully looked "holey" sweaters from mohair or angora. And despite their loose knitting, they come out very warm. An openwork blouse crochet knits on the same principle: first - the sample and calculation; after - a set of air loops by volume.
The process of knitting
On the bottom of the product is often knit a band of gum. However, in a large number of models it is not provided. In this case, the work begins immediately the main pattern.
Openwork blouse knits knit in fragments:front panel, back and two sleeves. The first two parts fit separately, each of them - in a straight line to the armhole, further from two sides form a cutout for the sleeve. At the neck, the loops begin to decrease according to the rollout of the selected model.
Above sleeves work simultaneously to maketheir most symmetrical. Knitting start with a small number of loops, equal to the volume of the wrist, then make an increase at the edges through the same number of rows. When the sleeve "reaches" to the height of the armhole, begin to design the okat, closing along the edges on both sides a few loops.
Modeling in knitting
Ажурная кофточка может быть выполнена лишь с some fragments of patterns that run along or across the front canvas, or completely connected with an interesting loose pattern. Ornament can be trimmed only the neck of the product or only the sleeves. Beautifully patterned sweaters on the buttons along the entire length or just near the neck. Whatever model is, the main thing is that she likes her mistress and emphasizes all the advantages of a female silhouette.
